Cisco WAP371 Wireless Dual Radio Access Point
Specifications |
Description |
|
Standards |
IEEE 802.11ac, 802.11n, 802.11g, 802.11b, 802.3af, 802.3u, 802.1X (security authentication), 802.1Q (VLAN), 802.1D (Spanning Tree), 802.11i (WPA2 security), 802.11e (wireless QoS), IPv4 (RFC 791), IPv6 (RFC 2460) |
|
Ports |
LAN Gigabit Ethernet autosensing |
|
Cabling type |
Category 5e or better |
|
Antennas |
Internal antennas optimized for installation on a wall or ceiling |
|
LED indicators |
Power, WLAN, LAN |
|
Operating system |
Linux |
|
Physical Interfaces |
||
Ports |
10/100/1000 Ethernet, with support for 802.3af/at PoE, power port for AC adapter (not included) |
|
Buttons |
Reset button |
|
Lock slot |
Slot for Kensington lock |
|
LEDs |
Power, Wireless, Ethernet |
|
Physical Specifications |
||
Physical dimensions (W x D x H) |
9.05 x 9.05 x 1.69 in. (230 x 230 x 43 mm) |
|
Weight |
1.81 lb or 740 g |
|
Network Capabilities |
||
VLAN support |
Yes |
|
Number of VLANs |
1 management VLAN plus 16 VLANs for SSIDs |
|
802.1X supplicant |
Yes |
|
SSID-to-VLAN mapping |
Yes |
|
Auto channel selection |
Yes |
|
Spanning tree |
Yes |
|
Load balancing |
Yes |
|
IPv6 |
Yes ● IPv6 host support
● IPv6 RADIUS, syslog, Network Time Protocol (NTP), etc.
|
|
Layer 2 |
802.1Q-based VLANS, 16 active VLANS plus 1 management VLAN |
|
Security |
||
WPA/WPA2 |
Yes, including Enterprise authentication |
|
Access control |
Yes, management access control list (ACL) plus MAC ACL |
|
Secure management |
HTTPS |
|
SSID broadcast |
Yes |
|
Rogue access point detection |
Yes |
|
Mounting and Physical Security |
||
Multiple mounting options |
Mounting bracket included for easy ceiling or wall mounting |
|
Physical security lock |
Kensington lock slot |
|
Quality of Service |
||
QoS |
Wi-Fi Multimedia and Traffic Specification (WMM TSPEC), Client QoS |
|
Performance |
||
Wireless throughput |
Up to 950-Mbps data rate (real-world throughput will vary) |
|
Recommended user support |
Up to 64 connective users, 30 active users per radio |
|
Multiple-Access Point Management |
||
Single Point Setup |
Yes |
|
Number of access points per cluster |
8 |
|
Active clients per cluster |
240 |
|
Configuration |
||
Web user interface |
Built-in web user interface for easy browser-based configuration (HTTP/HTTPS) |
|
Management |
||
Management protocols |
Web browser, Simple Network Management Protocol (SNMP) v3, Bonjour |
|
Remote management |
Yes |
|
Event logging |
Local, remote syslog, email alerts |
|
Network diagnostics |
Logging and packet capture |
|
Web firmware upgrade |
Firmware upgradable through web browser, imported/exported configuration file |
|
Dynamic Host Configuration Protocol (DHCP) |
DHCP client |
|
IPv6 host |
Yes |
|
HTTP redirect |
Yes |
|
Wireless |
||
Frequency |
Dual concurrent radios (2.4 and 5 GHz) |
|
Radio and modulation type |
Dual radio, orthogonal frequency division multiplexing (OFDM) |
|
WLAN |
802.11n/ac 3x3 multiple-input multiple-output (MIMO) with 3 spatial streams at 5 GHz 2x2 MIMO with 2 spatial streams at 2.4 GHz 20-, 40-, and 80-MHz channels for 802.11ac 20- and 40-MHz for 802.11n PHY data rate up to 1.6 Gbps 802.11 dynamic frequency selection (DFS) |
|
Data rates supported |
802.11a/b/g: ● 54, 48, 36, 24, 18, 12, 9, 6, 11, 5.5, 2, and 1 Mbps
● 802.11n: 6.5 to 450 Mbps
◦ 20-MHz bandwidth: MCS 0-15 for supported data rates
◦ 40-MHz bandwidth: MCS 0-15 for supported data rates
● 802.11ac: 6.5 to 1300 Mbps
◦ 20-MHz bandwidth: MCS 0-9 for supported data rates
◦ 40-MHz bandwidth: MCS 0-9 for supported data rates
◦ 80-MHz bandwidth: MCS 0-9 for supported data rates
|
|
Frequency band and operating channels |
802.11b 2412 2437 2462 802.11g 2412 2437 2462 802.11n 20 MHz (2.4-GHz Band) 2412 2437 2462 802.11n 40 MHz (2.4-GHz Band) 2422 2437 2452 |
802.11a 5180 5320 5500 5700 802.11n 20 MHz (5-GHz Band) 5180 5320 5500 5700 5825 802.11n 40 MHz (5-GHz Band) 5190 5510 5795 |
Nonoverlapping channels |
2.4 GHz ● 802.11b/g
◦ 20 MHz: 3
● 802.11n
◦ 20 MHz: 3
5 GHz ● 802.11a
◦ 20 MHz: 21
● 802.11n
◦ 20 MHz: 21
◦ 40 MHz: 9
● 802.11ac
◦ 20 MHz: 21
◦ 40 MHz: 9
◦ 80 MHz: 5
|
|
Transmitted output power |
2.4 GHz ● 802.11b: 17.0 +/- 1.5 dBm @ CH6, all rates
● 802.11g: 17.0 +/- 1.5 dBm @ CH6, 6 Mbps
● 802.11g: 15.0 +/- 1.5 dBm @ CH6, 54 Mbps
● 802.11n(HT20): 17.0 +/- 1.5 dBm @ CH6, MCS0
● 802.11n(HT20): 14.0 +/- 1.5 dBm @ CH6, MCS15
● 802.11n(HT40): 12.0 +/- 1.5 dBm @ CH6, all rates
5 GHz UNII-1 (5150 to 5250 MHz) ● 802.11a: 10 +/- 1.5 dBm @ all rates
● 802.11ac(HT20): 10 +/- 1.5 dBm @ all rates
● 802.11ac(HT40): 11 +/- 1.5 dBm @ all rates
● 802.11ac(HT80): 11 +/- 1.5 dBm @ all rates
5 GHz UNII-2 (5250 to 5350 MHz)/UNII-2 Extended (5470 to 5725 MHz) ● 802.11a: 16.0 +/- 1.5 dBm @ 6 Mbps
● 802.11a: 15.0 +/- 1.5 dBm @ 54 Mbps
● 802.11ac(HT20): 16.0 +/- 1.5 dBm @ MCS0
● 802.11ac(HT20): 13.0 +/- 1.5 dBm @ MCS9
● 802.11ac(HT40): 18.0 +/- 1.5 dBm @ MCS0
● 802.11ac(HT40): 13.0 +/- 1.5 dBm @ MCS9
802.11ac(HT80): 13.0 +/- 1.5 dBm @ all rates 5 GHz UNII-3 (5725 to 5850 MHz) ● 802.11a: 18.0 +/- 1.5 dBm @ 6 Mbps
● 802.11a: 15.0 +/- 1.5 dBm @ 54 Mbps
● 802.11ac(HT20): 18.0 +/- 1.5 dBm @ MCS0
● 802.11ac(HT20): 13.0 +/- 1.5 dBm @ MCS9
● 802.11ac(HT40): 18.0 +/- 1.5 dBm @ MCS0
● 802.11ac(HT40): 13.0 +/- 1.5 dBm @ MCS9
● 802.11ac(HT80): 18.0 +/- 1.5 dBm @ MCS0
● 802.11ac(HT80): 13.0 +/- 1.5 dBm @ MCS9
|
|
Wireless isolation |
Wireless isolation between clients |
|
External antennas |
None |
|
Internal antennas |
Internal fixed PIFA antenna |
|
Antenna gain in dBi |
2 dBi each antenna |
|
Receiver sensitivity |
2.4 GHz ● 802.11b: -86 dBm @ 11 Mbps
● 802.11g: -75 dBm @ 54 Mbps
● 802.11n(HT20): -69 dBm @ MCS15
● 802.11n(HT40): -66 dBm @ MCS15
5 GHz ● 802.11a: -79 dBm @ 54 Mbps
● 802.11ac(HT20): -62 dBm @ MCS9
● 802.11ac(HT40): -59 dBm @ MCS9
● 802.11ac(HT80): -57 dBm @ MCS9
|
|
Wireless distribution system (WDS) |
Yes |
|
Fast roaming |
Yes |
|
Multiple SSIDs |
16 |
|
Wireless VLAN map |
Yes |
|
WLAN security |
Yes |
|
Wi-Fi Multimedia (WMM) |
Yes, with unscheduled automatic power save |
|
Operating Modes |
||
Access Point mode, WDS Bridging, Workgroup Bridge mode |
||
Environmental |
||
Power options |
IEEE 802.3at Ethernet switch Cisco power injector: SB-PWR-INJ2-xx AC adapter: SB-PWR-12V2A-xx Peak power: 17W |
|
Compliance |
Safety: ● UL 60950-1
● CAN/CSA-C22.2 No. 60950-1
● IEC 60950-1
● EN 60950-1
Radio approvals: ● FCC Part 15.247, 15.407
● RSS-210 (Canada)
● EN 300.328, EN 301.893 (Europe)
● AS/NZS 4268.2003 (Australia and New Zealand)
EMI and susceptibility (Class B): ● FCC Part 15.107 and 15.109
● ICES-003 (Canada)
● EN 301.489-1 and -17 (Europe)
|
|
Operating temperature |
0° to 40°C (32° to 104°F) |
|
Storage temperature |
–20° to 70°C (–4° to 158°F) |
|
Operating humidity |
10% to 85% noncondensing |
|
Storage humidity |
5% to 90% noncondensing |
|
System memory |
256 MB RAM 128 MB flash |
|
Package Contents |
||
● Quick-start guide
|
||
Minimum Requirements |
||
● Web-based configuration: Java-enabled web browser
|